Blog

What are the common malfunctions of PE pipe-making machines?

Mar 27, 2026 Leave a message

Fault Category Common phenomena The main reason
Extrusion system malfunction The outer surface of the pipe is rough and lacks luster Improper temperature control (too low or too high), material buildup in the mold, or inappropriate cooling water temperature
  The inner surface has grooves or is rough Excessively high core temperature, water ingress into the cavity, or contaminants inside the mold
  There are yellowish-brown streaks or spots on the surface of the pipe Dead spots in the mold cause localized decomposition of the material; impurities in the raw material
  Bubbles on the surface of the pipe Blocked vacuum exhaust ports and excessive die head temperature have caused the material to decompose.
Dimensional and Geometric Defects Uneven wall thickness Uneven die head temperature, fluctuations in feed rate, and die gap misalignment
  Pipe ovality exceeds specifications Uneven cooling (due to spray angle or water temperature issues), gravitational force
  Outer diameter out of tolerance Fluctuations in vacuum level, mismatched drawing speed, and issues with the sizing sleeve dimensions
Vacuum and Setting Problems No vacuum or low vacuum Blockage in the vacuum pump inlet or piping, air leaks in the seals, or blockage of the small holes in the core mold
  A vibration ring has appeared inside the pipe Uneven flow from the sizing sleeve, improper pressure differential setting between the front and rear vacuum chambers, and uneven discharge from the main unit
Traction and Cutting Malfunctions Inaccurate cutting length measurement Encoder wheel not properly secured or wobbling; encoder malfunction; electrical interference
  Abnormalities in co-extruded identification strips Inappropriate choice of co-extrusion material, uneven material feed, and mismatched speeds
Mechanical and Electrical Failures Unstable power supply current Uneven feeding, damaged main motor bearings, malfunctioning heater, interference with the screw elements
  Abnormal vibration of the equipment Misalignment of equipment installation, improper screw clearance, wear on transmission components, loose base
  Main motor fan failure causing shutdown The motor cooling fan has stopped, causing the winding temperature to rise sharply
Post-welding defects Electrofusion Welding Anomalies Short circuit in the heating element inside the fitting; open circuit in the output
  The hydraulic system of the hot-melt butt welding machine is not functioning Low hydraulic fluid level, clogged fluid lines, damaged quick-connect fittings

 

 

Send Inquiry