⑴ Daily maintenance is a regular routine work that does not occupy the equipment operation hours and is usually completed during the start-up period. The focus is on cleaning the machine, lubricating the moving parts, tightening the loose threaded parts, and timely checking and adjusting the motor, control instruments, working parts and pipelines.
⑵ Regular maintenance is generally carried out after the extruder has been running continuously for 2500-5000h and stopped. The machine needs to be disassembled for inspection, measurement, and identification of the wear of the main parts, and the parts that have reached the specified wear limit should be replaced, and the damaged parts should be repaired.
⑶ Empty operation is not allowed to avoid screw and barrel rolling.
⑷ If an abnormal sound occurs during the operation of the extruder, it should be stopped immediately for inspection or repair.
⑸ Prevent metal or other debris from falling into the hopper to avoid damage to the screw and barrel. To prevent iron debris from entering the barrel, a magnetic attraction component or a magnetic frame can be installed at the material feeding port where the material enters the barrel. To prevent debris from falling into the material, the material must be screened in advance.
⑹ Pay attention to the cleanliness of the production environment, do not allow garbage impurities to mix into the material to block the filter plate, affect the product output, quality and increase the resistance of the die.
⑺ When the extruder needs to be stopped for a long time, anti-rust grease should be applied to the working surfaces of the screw, barrel, die, etc. Small screws should be hung in the air or placed in a special wooden box, and leveled with wooden blocks to prevent the screw from deformation or bruises.
⑻ Regularly calibrate the temperature control instrument to check the correctness of its adjustment and the sensitivity of control.
⑼ The maintenance of the reducer of the extruder is the same as that of the general standard reducer. It is mainly to check the wear and failure of gears, bearings, etc. The reducer should use the lubricating oil specified in the machine manual, and add oil according to the specified oil level. Too little oil, insufficient lubrication, and reduced the service life of parts; too much oil, high heat, high energy consumption, and easy deterioration of oil, which also makes the lubrication ineffective, resulting in damage to parts. The seal gasket of the oil leaking part of the reducer should be replaced in time to ensure the amount of lubricating oil.
⑽ The inner wall of the cooling water pipe attached to the extruder is prone to scale and the outer surface is prone to corrosion and rust. Careful inspection should be carried out during maintenance. Excessive scale will block the pipe and fail to achieve the cooling effect. Severe rust will cause water leakage. Therefore, descaling and anti-corrosion cooling measures must be taken during maintenance.
⑾ For the DC motor that drives the screw, it is necessary to focus on checking the brush wear and contact conditions. Whether the insulation resistance value of the motor is above the specified value should also be measured frequently. In addition, check whether the connecting wires and other parts are rusted, and take protective measures.
⑿ Designate a person to be responsible for equipment maintenance. And record each maintenance and repair in detail and include it in the factory equipment management file.
Maintenance Of Auxiliary Equipment For Plastic Extruders
May 17, 2025
Leave a message
Send Inquiry
